Справочник Пользователя для Q-Logic QLA2342
B – Command Line Interface
Hotreset Command
Hotreset Command
B-18
59021-09 A
0
Hotreset Command
Resets the switch for the purpose of activating the pending firmware without
disrupting traffic. This command terminates all management sessions, saves all
configuration information, and clears the alarm log. After the pending firmware is
activated, the configuration is recovered. This process takes less than 80
seconds. To save the alarm log to a file before resetting, refer to the
disrupting traffic. This command terminates all management sessions, saves all
configuration information, and clears the alarm log. After the pending firmware is
activated, the configuration is recovered. This process takes less than 80
seconds. To save the alarm log to a file before resetting, refer to the
.
Authority
Admin session
Syntax
hotreset
Notes
You can load and activate version 4.0.x firmware on an operating switch without
disrupting data traffic or having to re-initialize attached devices under the following
conditions:
disrupting data traffic or having to re-initialize attached devices under the following
conditions:
The current firmware version is a 2.0, 3.0, or a 4.0.x version that precedes
the upgrade version.
the upgrade version.
No changes are being made to switches in the fabric including powering up,
powering down, disconnecting or connecting ISLs, and switch configuration
changes.
powering down, disconnecting or connecting ISLs, and switch configuration
changes.
No port in the fabric is in the diagnostic state.
No zoning changes are being made in the fabric.
No changes are being made to attached devices including powering up,
powering down, disconnecting, connecting, and HBA configuration changes.
powering down, disconnecting, connecting, and HBA configuration changes.
Ports that are stable when the non-disruptive activation begins, then change
states, will be reset. When the non-disruptive activation is complete, SANsurfer
Switch Manager sessions reconnect automatically. However, Telnet sessions
must be restarted manually. This command clears the event log and all counters.
states, will be reset. When the non-disruptive activation is complete, SANsurfer
Switch Manager sessions reconnect automatically. However, Telnet sessions
must be restarted manually. This command clears the event log and all counters.