Справочник Пользователя для Q-Logic 5800V

3–Installation

Installing a Switch

59265-02  B

3-13



Serial—Windows: Open the HyperTerminal application on a Windows 
platform.

a.

Click the Start button, and then select Programs, Accessories, 
HyperTerminal, and then HyperTerminal.

b.

Select the connection you created earlier, and then click OK.



Serial—Linux: Open a command window, and then type the following 
command:



Serial—Solaris: Open a command window, and then type the following 
command:

2.

Open an admin session, and then enter the Set Setup System command. 
Type the values you want for switch IP address (EthNetworkAddress) and 
the network mask (EthNetworkMask). For example:

Switch #> admin start

Switch (admin) #> set setup system

3.

Open a Config Edit session, and then use the Set Config Switch command 
to modify the switch configuration. For example:

Switch (admin) #> config edit

Switch (admin-config) #> set config switch

For more information about the CLI commands, refer to the QLogic 5800V Series 
Fibre Channel Switch Command Line Interface Guide.

Connect cables to the SFP transceivers and their corresponding devices, and 
then power up the devices. Device adapters can have SFP (or SFF) transceivers. 
LC-type duplex fiber optic cable connectors are designed for SFP transceivers. 
Duplex cable connectors are keyed to ensure correct orientation. Choose the fiber 
optic cable with the connector combination that matches the device adapter.

GL_Ports self-configure as FL_Ports when connected to loop of devices, or 
F_Ports when connected to a single device. G_Ports self-configure as F_Ports 
when connected to a single device. Both GL_Ports and G_Ports self-configure as 
E_Ports when connected to another switch.