Справочник Пользователя для Q-Logic 5800V
4–Diagnostics/Troubleshooting
Power-On Self Test Diagnostics
59265-02 B
4-5
Configuration File System Error Blink Pattern
A configuration file system error blink pattern is four blinks followed by a
two-second pause. The four-blink error pattern indicates that a configuration file
system error has occurred, and that the configuration file must be restored.
two-second pause. The four-blink error pattern indicates that a configuration file
system error has occurred, and that the configuration file must be restored.
Figure 4-4. Configuration File System Error Blink Pattern
To restore the switch configuration:
1.
Establish communications with the switch using Telnet. Type one of the
following on the command line:
following on the command line:
telnet xxx.xxx.xxx.xxx
or
telnet switchname
where xxx.xxx.xxx.xxx is the switch IP address and switchname is the
switch name associated with the IP address.
switch name associated with the IP address.
2.
A Telnet window opens prompting you for a login. Type an account name
and password. The default account name and password are admin and
password.
and password. The default account name and password are admin and
password.
3.
Open an admin session to acquire the necessary authority. For example:
Switch $>admin start
4.
Restore the configuration. When the restore is complete, the switch will
reset. For example:
reset. For example:
Switch (admin) $>config restore
If a configuration does not exist, enter the Config Backup command, and
then enter the Config Restore command.
then enter the Config Restore command.
Two seconds