Справочник Пользователя для Netgear M4100-50G-POE+
Age Time
(seconds)
(seconds)
Response Time
(seconds)
(seconds)
Retries
Cache Size
Dynamic Renew
Mode
Mode
Total Entry
Count Current /
Peak
Count Current /
Peak
Static Entry
Count Current /
Max
Count Current /
Max
Routing Commands
227
ProSafe M4100 and M7100 Managed Switches
show arp switch
This command displays the contents of the switch’s Address Resolution Protocol (ARP)
table.
table.
Format
show arp switch
Mode
IP Address
MAC Address
Interface
IP Routing Commands
This section describes the commands you use to enable and configure IP routing on the
switch.
switch.
routing
This command enables IPv4 and IPv6 routing for an interface. You can view the current
value for this function with the show ip brief command. The value is labeled as “Routing
Mode.”
value for this function with the show ip brief command. The value is labeled as “Routing
Mode.”
Term
Definition
The time it takes for an ARP entry to age out. This value is configurable. Age time is
measured in seconds.
measured in seconds.
The time it takes for an ARP request timeout. This value is configurable. Response time
is measured in seconds.
is measured in seconds.
The maximum number of times an ARP request is retried. This value is configurable.
The maximum number of entries in the ARP table. This value is configurable.
Displays whether the ARP component automatically attempts to renew dynamic ARP
entries when they age out.
entries when they age out.
The total entries in the ARP table and the peak entry count in the ARP table.
The static entry count in the ARP table and maximum static entry count in the ARP table.
Privileged EXEC
Term
Definition
The IP address of a device on a subnet attached to the switch.
The hardware MAC address of that device.
The routing slot/port associated with the device’s ARP entry.
Default
disabled