Справочник Пользователя для Fujitsu eLux NG S26361-F2600-L134
Модели
S26361-F2600-L134
www.
myelux
.com
eLux
®
NG
Build # 27
118
Installing the OneBridge Sync client on the MetaFrame server
The OneBridge Sync client must be installed on your MetaFrame server you plan to connect
to.
For information on purchasing and installation, see
The OneBridge Sync client must be installed on your MetaFrame server you plan to connect
to.
For information on purchasing and installation, see
Installing the client software on the PDA
Use the CD and documentation that came with the PDA to install the client on the PDA.
Use the CD and documentation that came with the PDA to install the client on the PDA.
Mapping the COM port
Configure COM port settings as described in “4.2.6 COM Port Mapping.”
In the COM Port Device Selection dialog enter the following parameter:
• Tungsten:
Configure COM port settings as described in “4.2.6 COM Port Mapping.”
In the COM Port Device Selection dialog enter the following parameter:
• Tungsten:
/dev/palm/0
• iPAQ:
/dev/usb/tts/0
• USB v. 24 converter (PL2303 chip only):
/dev/usb/tts/0
When you use the net use command, write down the COM port number you mapped to on
the MetaFrame server.
Accessing the handheld within an ICA session
1. In the eLux NG starter, configure a remote desktop ICA session.
• For more information, see “4.2.1 Remote Desktop.”
2. Start the session (Applications > Connect). The Windows desktop appears.
3. In the ICA session, start the OneBridge Sync client and go to the Desktop Connector.
3. In the ICA session, start the OneBridge Sync client and go to the Desktop Connector.
Select the COM port number you mapped to on the MetaFrame server and click
Enable
Enable
.
Note: This only needs to be performed once. Settings will be saved for future
sessions.
sessions.
4. Perform the desired operations with the handheld.