Справочник Пользователя для 3com 3CRWXR10095A

To deploy all the changes, click Deploy. 3WXM compares the changes to 
the verification rules, and lists any warnings or error messages. If there 
are any errors, 3WXM will not deploy the changes. To deploy the 
changes, you must first resolve the errors. To resolve configuration errors, 
use the Verification option. (See “” on page 363.)

1 Access the Create Wireless Switch wizard:

a Select the Configuration tool bar option.

b In the Organizer panel, select the network plan name.

c In the Task List panel, select the Wireless Switch task. 

2 In the WX Name box, type the name of the WX switch (1 to 256 

alphanumeric characters, with no spaces or tabs).

3 In the WX Model list, select the WX switch model. 

4 In the Software Version list, select the version of Mobility System 

Software (MSS) you expect to run on the WX switch.

5 In the Enable Password box, type the enable password for the WX. 

This password must match the enable password that was defined on the 
switch using the CLI command set enablepass. For more information, 
see the 

.

The password is encrypted when you type it.

6 Click Next.

7 Edit the IP address and network mask in the IP Address field. 

3WXM will assign this IP address to the default VLAN (VLAN 1).

8 Click Next.

9 In the Available Members list, select the ports to add to the default VLAN 

and click Add or Move. 

„

The Add button adds the ports to the new VLAN without removing 
them from any other VLANs.