Справочник Пользователя для 3com 3C17501
Booting the Switch 8800
33
Powering up and
Booting
Turn on the power for the Switch 8800 and run the BootROM program. The
terminal displays the following information:
terminal displays the following information:
Starting...
*************************************************
* *
* Switch 8800 Bootrom, Version 113 *
* *
*************************************************
Copyright(C) 2000-2004 by 3COM Corporation, Inc.
Creation date: Jul 5 2004, 10:43:58
CPU type : MPC755
CPU L2 Cache : 1024KB
CPU Clock Speed : 400MHz
BUS Clock Speed : 100MHz
Memory Size : 512MB
Flash file system init....done
Board self testing...........................
The board is steady
SlotNo of this board is 4
The MCX is existent
BootRom main system CRC check is OK
82559 register testing is OK
EPLD1 testing is OK
EPLD2 testing is OK
16c2552 register testing is OK
Please check LEDs......................LED testing finished
The switch's Mac address is 0040.9c30.b2d4
Press Ctrl+B to enter Boot Menu... 5
To enter Boot Mode (see Chapter 6), press Ctrl+B during the 5 seconds that “Press
Ctrl+B to enter Boot Menu...5” is displayed. To perform decompression
immediately, press ESC while this message is displayed. If you do nothing, the
system enters the following auto-booting port within 5 seconds:
Ctrl+B to enter Boot Menu...5” is displayed. To perform decompression
immediately, press ESC while this message is displayed. If you do nothing, the
system enters the following auto-booting port within 5 seconds:
Auto-booting...
Booting from Flash...
Decompress
Image...............................................................
....................................................................
.....OK!
Starting at 0x10000...
User interface con0 is available.
The display of these messages indicates the completion of the switch
auto-booting. Press Enter and the terminal screen displays:
auto-booting. Press Enter and the terminal screen displays:
<3Com>
Now you can begin the configuration for the Switch 8800.