Справочник Пользователя для 3com 1000BASE

Скачать
Страница из 6
The module requires management software version 
2.42 or later to be installed on the Switch. For 
instructions on upgrading management software, refer 
to the documentation supplied with your Switch.
Support for the management software is supplied by 
3Com Transcend
®
 Network Control Services. 
When the module is installed in a suitable Switch, the 
Switch interfaces contain features to monitor the 
auto-negotiation system specified in the IEEE 802.3 
Ethernet standard. This system allows the module port 
to automatically detect the flow control setting of a 
Gigabit Ethernet link.
The
 Current Flow Control field in the Web interface 
displays the method of flow control currently used by 
the module port. If auto-negotiation is not yet 
complete, 
Not Determined
 is displayed.
It is not possible to disable the auto-negotiation system 
through either the Web or the Command Line Interface. 
An error message is displayed if you try to disable 
auto-negotiation on the module through the Command 
Line Interface.
The module port has restricted functionality — for 
details, see “Module Port Restrictions” below. As a 
consequence, the Port Setup page for the port does not 
contain all the standard listboxes.
When using the module port, note the following:
„
The port only operates in full duplex.
„
The port only supports full duplex flow control in 
symmetrical mode, as defined by the Gigabit 
Ethernet standard. You cannot disable or alter this 
mode.
„
The port only supports the Store and Forward 
forwarding mode.
„
The port does not support PACE.
„
You cannot manage the port using the Internetwork 
Packet Exchange protocol (IPX).
„
The port cannot be part of a port trunk.
„
The port does not support VLT tagging.
„
You cannot create a resilient link pair that includes 
the port and another port that uses VLT tagging.
„
You cannot disable auto-negotiation in the module.
„
You can only restart auto-negotiation using SNMP, 
and not from the Web interface or from the 
Command Line Interface.
For information on other module port restrictions, refer 
to the documentation supplied with your Switch.
If you suspect a problem, carry out these steps before 
contacting your supplier:
„
Ensure that the Switch in which the module is fitted 
is turned on.
„
Ensure that the module is correctly installed in the 
Switch.
„
Ensure that the device at the far end of the link is 
on and operating correctly.
„
Ensure that all connectors on the cable are correctly 
engaged.
„
Ensure that the cabling installation conforms to the 
Category 5 standard. A white paper which describes 
this standard is available from the 3Com web site.
For more general problem solving information, refer to 
the documentation supplied with your Switch.
M
ANAGING
 
THE
 M
ODULE
M
ODULE
 P
ORT
 R
ESTRICTIONS
P
ROBLEM
 S
OLVING
3