Справочник Пользователя для 3com 10014917
22
3Com Switch 4200G Family
Command Reference
interface
Use the command
interface
command to enter Ethernet port view. To configure parameters for a port, you
must enter the port view first.
System view
interface VLAN-interface
Use the
interface vlan-interface
command to create a management VLAN interface and enter
management VLAN interface view.
System view
Web command: Device -> VLAN Interface
Administration -> IP Setup
ip address
Use the
ip address
command to assign an IP address (and mask) to a management VLAN interface.
VLAN Interface view
Web command: Administration -> IP Setup -> Device -> VLAN
ip address bootp-alloc
Use the
ip address bootp-alloc
command to configure VLAN interface to obtain IP address using
BOOTP.
VLAN Interface view
ip address dhcp-alloc
Use the
ip address dhcp-alloc
command to configure VLAN interface to obtain an IP address using
DHCP.
VLAN Interface view
ip host
Use the
ip host
command to configure a host name and the corresponding IP address for a switch.
System view
ip http acl
Use the
ip http acl
command to apply an ACL to filter Web users.
System view
User Interface view
ip-pool
Use the
ip-pool
command to configure a private IP address range for cluster members on the switch to
be set as the management device.
Cluster view
ip route-static
Use the
ip route-static
command to configure a static route.
Use the
ip route-static
command to configure a static route, whose validity depends on detecting results
as follows: valid when the detecting result is reachable or invalid when the detecting result is unreachable.
System view
Web command: Device -> IP Route
ip route-static
Use the
ip route-static
command to configure a static route, whose validity depends on detecting results
as follows: valid when the detecting result is reachable or invalid when the detecting result is unreachable.
System view
key
Use the
key
command to specify a shared key for the RADIUS authentication/authorization packets or
accounting packets.
RADIUS Scheme view
Web command: Security -> RADIUS Client
lacp enable
Use the
lacp enable
command to enable the LACP protocol on the current port.
Ethernet Port view
Web command: Port -> LACP
lacp port-priority
Use the
lacp port priority
command to configure port priority value.
Ethernet Port view
lacp system-priority
Use the
lacp system-priority
command to configure system priority value.
System view
Web command: Port -> LACP