Справочник Пользователя для Sony 9000
351
Frame Memory Operations
Ch
apt
apt
er 7
F
rame Memo
ry
1
In the auxiliary bus control block, press the AUX delegation button to
which frame memory source bus 1 is allocated, turning it on.
which frame memory source bus 1 is allocated, turning it on.
For allocation of buses to the AUX delegation buttons, see “AUX
Delegation Buttons Settings (Aux Assign Menu)” in Chapter 16 (Volume
2).
Delegation Buttons Settings (Aux Assign Menu)” in Chapter 16 (Volume
2).
2
In the auxiliary bus control block cross-point buttons, select the signal to
be used for the input image.
be used for the input image.
To select a signal with a key or DME effect applied on the frame
memory source bus
memory source bus
In the key control block, press the [FM FEED] button, turning it on.
This automatically assigns the key fill and key source signals being keyed by
the currently selected keyer to frame memory source buses 1 and 2.
When DME is selected on the keyer, the key fill and key source signals to
which a DME effect is applied are assigned.
This automatically assigns the key fill and key source signals being keyed by
the currently selected keyer to frame memory source buses 1 and 2.
When DME is selected on the keyer, the key fill and key source signals to
which a DME effect is applied are assigned.
Selecting Outputs and Target Frame Memory
Selecting outputs (FM) and target frame memory
The signals of frame memory source buses 1 and 2 are used assigned to one of
the pairs of FM1&2, FM3& 4, FM5&6, and FM7&8. The following
description applies to the case of assignment to FM1&2, but the procedures are
similar for the other cases.
the pairs of FM1&2, FM3& 4, FM5&6, and FM7&8. The following
description applies to the case of assignment to FM1&2, but the procedures are
similar for the other cases.
1
In the Frame Memory menu, press one of VF1 to VF3, and select the
required HF menu.
required HF menu.
The current status of frame memory appears in the status area. (See page
349.)
349.)
2
If required, press [Pair], to select the FM operation mode (pair mode).
On: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) as a pair.
Off: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) individually.
Off: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) individually.
For more details, see “Pair mode” (page 73).
3
In the <Select> group, press [FM1 & FM2] to select it.
This assigns the signals to FM1 and FM2.
To the right of the target FM selection buttons (see page 349), the FM
output status appears.
To the right of the target FM selection buttons (see page 349), the FM
output status appears.