Справочник Пользователя для Bay Technical Associates 304
Installing the BayStack Switches
893-01010-A
2-15
Initial Setup of a BayStack Ethernet Switch
In most cases, the BayStack 303 and 304 Ethernet Switches can be installed and
made operational using the system default settings.
made operational using the system default settings.
Minimal configuration is required when you plan on remote management or TFTP
operations. In that case, you need to enter the IP address of the switch, the subnet
mask, and the gateway address. Refer to
operations. In that case, you need to enter the IP address of the switch, the subnet
mask, and the gateway address. Refer to
,” for more information about configuring your BayStack
303 or 304 switch.
Using Factory Default Settings
When you turn on power to the switch, it begins operation using the factory
default settings for configuration parameters.
default settings for configuration parameters.
lists default values for the
parameters.
Table 2-1.
Factory default settings
Parameter
Default value
Language
None
IP Address
127.0.0.2
IP Subnet Mask Address
255.255.255.0
Default Gateway Address
0.0.0.0
Spanning Tree Protocol
Enabled
Telnet Access
Enabled
Authentication Trap Generation
Enabled
Password (Telnet)
No password assigned
Port Path Cost
0
Port Priority
128
High Speed Port Half or Full Duplex
Half Duplex
High Speed Port Speed
Auto
Spanning Tree Priority
32768
Active Aging Time
300 seconds
Designated Root
32768 - 00.00.00.00.00.00
Hello Time
2 seconds
89301010.BK Page 15 Tuesday, June 10, 1997 8:00 PM