Справочник Пользователя для Barco DCS-200

This appendix provides information regarding remote control protocol.   The following 
topics are discussed:  

„

Use the following steps to communicate with the DCS-200 via Telnet:

1.  Connect the DCS-200’s Ethernet port to an Ethernet switch, and connect the 

switch to your PC or laptop.  

2.  Ensure that all Ethernet parameters are properly set up.  In Chapter 4, refer to the 

“

” section on page 74 for details.

3.  For Telnet communications, use the DCS-200’s IP address and port 23.  On a 

Microsoft Windows PC, open a command prompt window and enter the following:

4.  After you “Telnet” into the DCS-200, you are presented with the login prompt:

a.  Type “user” and press ENTER to login.

b.  When prompted for a password, press ENTER.

Once you have successfully logged in, the following message appears, along with 
the command prompt (>):

5.  You can now issue commands.  Operationally, the telnet window functions in a 

manner similar to a serial communications session.  As required, type "help" to 
see a list of supported commands.  

Refer to the “

” section on page 134 for a complete list of commands.