Справочник Пользователя для Barco DCS-200

Using the Setup Menu

When In Auto Acquire is 

, and the input source is digital, the system uses the following 

search order:

Saved configuration files defined in the File Association Menu for each input 
channel

The user’s library of saved files

Direct measurement of the signal

If the input signal’s timing is too different from the saved configuration, a good lock may not 
be possible.  In this situation, the "Invalid Signal" message is displayed,  and the video 
output will be black.  You will also see "Invalid Signal" if the configuration file for an input 
has been deleted.

Please note the following important points:

It is recommended that you leave the In Auto Acquire mode 

.  Then, if the 

timing changes on any input (whether or not you have a saved config file), you will 
always get an output image.  On the other hand, if the mode is 

 and the input 

timing changes, the output will be black.

When the In Auto Acquire mode is 

, the DCS-200 automatically detects and 

acquires the input video type and resolution (in most cases), and limits menu 
selections to those applicable to the detected video type. 

If you are an advanced user and you know the exact timing parameters for your 
input(s), you can turn the In Auto Acquire mode 

, and dial in your timing 

parameters manually.  

The Auto Input Config function enables or disables the automatic input configuration 
mode.  Values are:  

 and 

 (default).  

When you turn In Auto Acquire 

, the DCS-200 

automatically turns Auto Input Config and Auto Input Save 

 as well. Similarly, if you turn In Auto Acquire 

, Auto 

Input Config and Auto Input Save turn 

 as well.  If you 

wish to adjust these fields independently, you can still do so.

If you have already saved configuration files for your inputs, it 
is recommended that you turn the In Auto Acquire mode 

.  This provides the fastest transition times.  When the 

mode is 

, transition times will be greater, due to the time 

required to analyze the input timing for each source.

This is the “automatic” version of the manual Auto Config 
mode, which is located in both the Image Adjust Menu, and 
the Timing Adjust Menu.  Refer to the “

section on page 57 for details.

The In Auto Acquire mode must be 

, in order for the Auto 

Input Cfg mode to function.  If In Auto Acquire is 

, the 

Auto Input Cfg mode is bracketed.