Справочник Пользователя для Barco DCS-200

Using the Setup Menu

To clear the message and continue operations, press ESC.   

From the System Menu, select Diagnostics to display the Diagnostics Menu: 

Figure 4-55.  Diagnostics Menu 

If you suspect a problem with the DCS-200, press SEL to run a series of internal diagnostic 
tests.  The menu will report back “PASS” or “FAIL.”  

From the System Menu, select Save Config to save all current “system” settings so that 
they may be restored at power up.  A message is briefly shown, after which the DCS-200 
returns to the System Menu.   

Figure 4-56.  Saving System Configuration Message

Please note the following important points regarding the system configuration file:

When you perform the Save Config function, all configuration parameters from 
the System Menu are saved in non-volatile memory.  If you do not perform the 
function, data will not be restored upon the next system power up sequence.

This command also saves the current input as the default power-up selection.  

This message is a warning only, which does not prevent the 
operation of the DCS-200.  If this message appears, it is 
recommended that you contact Barco Customer Service.

D I A G N O S T I C S
> S E L   =   S t a r t   T e s t s

If the menu reports “FAIL,” contact Barco Customer Service.  
In Appendix C, refer to the “

” section on 

page 160 for contact details.

S a v i n g   S y s t e m   C o n f i g . . .

If you want the DCS-200 to always power up and acquire an 
input other than input 1, perform the Save System State 
command while the desired input is selected on Program.