Справочник Пользователя для Barco DCS-200

Using Keys

When the “Key Auto Take” function is 

 in the User Preference Menu, you do not need 

to press TAKE to perform a key transition.  The transition occurs immediately, once the 
KEY button is pressed.  In addition, if a source is pending, it remains pending after the 
transition.  There is no flip-flop.

„

Use the following steps to mix a key up or down, when Key Auto Take is 

: 

1.  Press KEY.  The system immediately mixes the key up or down, at the current 

transition rate.  Please note:

If the transition is a “key up,” the KEY button blinks fast during the 
transition interval, then lights solid when the key is fully on Program.

If the transition is a “key down,” the KEY button blinks fast during the 
transition, then automatically turns off when the key is off Program.    

Refer to the “

” section on page 97 for descriptions of the 

many key combinations that can be performed with the DCS-200. 

In this section, brief instructions are provided for each individual key transition.  Please 
remember the following points:

If Menu Context is 

, the Key Setup Menu appears when the KEY button is 

pressed.  

Key Clip, Gain, Opacity, H offset and V offset can only be adjusted when the 
key is visible on Program.  The Key Input field, however, can only be changed 
when the key is off Program.  Once the key is on, the Input field is bracketed. 

Whenever TAKE is pressed, the current Program source and the pending 
program source will flip-flop.  If you do not want to transition to a new source, 
simply press the blinking source button to “un-pend” it. 

The following combinations are described:

If Menu Context is 

, the Key Setup Menu appears when 

you press KEY, enabling you to change the key source or 
adjust properties.  However, because Key Auto Take is 

, 

parameters cannot be adjusted until the transition is over.