Справочник Пользователя для ALTINEX TNP100-HB

 
 
 
 
 
 

 

 

 

Step 1. Cut an opening into the table’s surface. 

Refer to diagram 5 on page 7 of the 
manual for table cutout requirements. 

 Note: The table can be 3 inches or thinner 

in thickness. Always confirm dimensions 
before cutting to insure that specifications 
have not changed.  

Step 2. Insert the TNP100-HB into the opening in 

the table.  

Step 3. Place the support brackets under the table 

and place them between the support 
mount grooves on the side of the TNP100-
HB unit. Attach the brackets to the groove 
at the desired height and secure them to 
the bottom of the table using the 6-32 
screw. There are two support brackets, 
one for each side of the unit. (See Figure 
1) 

table using support brackets and set screws  

 

 
Step 4. Secure the cables by using the provided 

cable clamp (See Figure 2). Pass the 
power cord from the bottom of the housing 
and attach it to the table using the cable 
clamp supplied with the TNP100-HB unit. 
Do not keep the cord too tight or too loose 
(See Diagram 4, page 6). 

 

 

Step 5.  Connect the appropriate cables with the 

correct input connectors. There are 
connections for Computer Video (15-pin 
HD), Audio (Stereo Mini), Modem (RJ-11), 
Network (RJ-45) and Microphone (XLR 4-
pin) on the front panel.  

Step 6. Once you have applied power and 

connected the proper cables on the bottom 
of the unit, you may raise the unit. To raise 
the TNP100-HB into position, lift the top by 
pulling upward at the notch in the top plate. 

Step 7. To lower the unit, push on the top of the 

TNP100-HB until it fits into place.