Справочник Пользователя для Acer G610
47
Installing and removing storage
devices
devices
The Altos G610 system supports one 3.5-inch and five 5.25-inch internal
storage devices. The empty drive bays allow you to install additional
drives such as a CD-ROM drive, a digital audio tape (DAT) drive or
another hard disk drive. These would provide your system additional
storage capacity.
storage devices. The empty drive bays allow you to install additional
drives such as a CD-ROM drive, a digital audio tape (DAT) drive or
another hard disk drive. These would provide your system additional
storage capacity.
Note: Your basic system already comes pre-installed with a CD-
ROM drive and a 3.5-inch floppy drive.
ROM drive and a 3.5-inch floppy drive.
Replacing the 3.5-inch floppy drive
1
Remove the housing panels. Refer to page 38 for more detailed
instructions.
instructions.
2
Disconnect the power and signal cables from the old drive.
3
Detach the old 3.5-inch drive with the drive frame from the
housing by removing the two chassis screws. Keep the screws for
later use.
housing by removing the two chassis screws. Keep the screws for
later use.
4
Remove the four frame screws that hold the old drive to the drive
frame then pull out the drive.
frame then pull out the drive.
5
Install a new 3.5-inch drive to the drive frame and secure it with
the four frame screws you have previously removed.
the four frame screws you have previously removed.
AA G600.book Page 47 Thursday, August 23, 2001 2:31 PM