Справочник Пользователя для Acer G610
3 Upgrading your system
52
3
Remove the four tray screws to open the drive tray. Keep the
screws for later use.
screws for later use.
4
When applicable, pull out any previously installed hard disk.
5
Install a hard disk on the drive tray then secure it with the four
tray screws you have removed earlier.
tray screws you have removed earlier.
6
Insert the tray into the hot-swap cage with the lever still extended.
Make sure that the drive is properly inserted before closing the
lever.
Make sure that the drive is properly inserted before closing the
lever.
7
Push the lever back until it clicks into place.
Replacing a 5.25-inch storage device (optional)
Note: If you are installing a new drive in an empty drive bay, skip
steps 2 to 4.
steps 2 to 4.
To replace a 5.25-inch storage device:
1
Remove the housing panels. Refer to page 38 for more detailed
instructions.
instructions.
2
Detach the power and signal cables from the drive.
AA G600.book Page 52 Thursday, August 23, 2001 2:31 PM