Справочник Пользователя для Lenovo 3824
1
Release latch
2
Drive tray handle (in open position)
3
Drive tray
4
Hard disk drive
7. If you are instructed to return the 2.5-inch hot-swap hard disk drive, follow all
packaging instructions, and use any packaging materials that are supplied to
you for shipping.
you for shipping.
Installing a 2.5-inch hot-swap hard disk drive
Before installing a 2.5-inch hot-swap hard disk drive, read the following information:
v
The 2.5-inch hot-swap drives must be either all SAS hard disk drives or all SATA
hard disk drives; do not mix SAS and SATA drives.
hard disk drives; do not mix SAS and SATA drives.
v
Inspect the drive tray for signs of damage.
v
To maintain proper system cooling, do not operate the server for more than 10
minutes without either a drive or a filler panel installed in each drive bay.
minutes without either a drive or a filler panel installed in each drive bay.
v
You do not have to turn off the server to install hot-swap drives in the hot-swap
drive bays.
drive bays.
Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this section.
instructions in addition to the instructions in this section.
Attention:
Static electricity that is released to internal server components when
server is powered-on might cause the server to halt, which might result in the loss
of data. To avoid this potential problem, always use an electrostatic-discharge wrist
strap or other grounding system when you work inside the server with the power
on.
of data. To avoid this potential problem, always use an electrostatic-discharge wrist
strap or other grounding system when you work inside the server with the power
on.
To install a 2.5-inch hot-swap hard disk drive, do the following:
Attention:
To maintain proper system cooling, do not operate the server for more
than 10 minutes without either a drive or a filler panel installed in each bay.
Chapter 5. Installing optional devices and replacing customer replaceable units
71