Справочник Пользователя для HP (Hewlett-Packard) ML110 G6
Removal and replacement procedures 49
Memory
The system has four DIMM slots that support PC3-10600E unbuffered DIMM (UDIMM) with ECC
support. The DIMM slots are divided into two channels of two DIMM slots each.
support. The DIMM slots are divided into two channels of two DIMM slots each.
Item
Connector code
Slot type
1
DIMM4B
Channel B 1
st
DDR3 DIMM slot
2
DIMM3D
Channel B 2
nd
DDR3 DIMM slot
3
DIMM2A
Channel A 1
st
DDR3 DIMM slot
4
DIMM1C
Channel A 2
nd
DDR3 DIMM slot
Memory installation guidelines
Observe the following important guidelines when installing memory modules:
•
Use only HP supported PC3-10600E UDIMM in 1 GB, 2 GB, or 4 GB capacities.
•
Supported DIMM configurations include:
○
Single DIMM (non-interleaving) – It must be installed in the DIMM2A slot.
NOTE:
To allow an interleaving memory configuration, the Memory Interleaving field in the
Advanced | Advanced Chipset Control menu of the BIOS Setup must be set to Enabled.
○
Two DIMMs (interleaving) – For optimum memory performance, install in the DIMM2A and
DIMM4B slots.
○
Four DIMMs
•
When modules of varying speed are installed, the system will run at the fastest common
frequency as determined through the SPD registers on the memory modules.