Справочник Пользователя для Gateway 7400
Replacing the SCSI backplane
77
Replacing the SCSI backplane
The six drive SCSI backplane is at the back of the drive cage. The backplane
supports as many as six hot-pluggable LVD SCSI drives. The backplane
provides activity LEDs for each drive.
supports as many as six hot-pluggable LVD SCSI drives. The backplane
provides activity LEDs for each drive.
To replace the SCSI backplane:
1
Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
installed), and all external peripheral devices.
2
Observe all safety and static electricity precautions. (See “Preventing static
electricity discharge” on page 22.)
electricity discharge” on page 22.)
3
Remove the bezel. (See “Removing the bezel” on page 25.)
4
5
Disconnect all cables to the hot-plug backplane, noting the connector
locations so you can reconnect them after replacing the backplane.
locations so you can reconnect them after replacing the backplane.
6
Remove all hot-plug drives, being careful to note which drive was in
which slot.
which slot.
8508366.book Page 77 Tuesday, October 23, 2001 11:29 AM