Справочник Пользователя для Lucent Technologies 555-233-115
Upgrading G3rV2, V3, V4 to R8r and Adding Memory
1-1
1
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
1
Upgrading G3rV2, V3, V4 to R8r and
Adding Memory
Adding Memory
This chapter provides the information necessary to upgrade the software from a
DEFINITY G3rV2, V3, or V4 system to a Release 8r system. The chapter also
provides information on replacing the following hardware:
DEFINITY G3rV2, V3, or V4 system to a Release 8r system. The chapter also
provides information on replacing the following hardware:
■
The TN1657 disk drive if drive is not Vintage 4 or later.
■
The TN 1656 tape drive with the TN2211 optical drive
■
The UN332/B MSSNET circuit pack with the UN332C circuit pack
(required for the optical drive)
(required for the optical drive)
■
A TN1650B memory circuit pack if the system does not contain 3 of these
circuit packs
circuit packs
NOTE:
Adding memory to the standby SPE causes an error because the memory
number between the standby and active carriers does not match.
number between the standby and active carriers does not match.
If the system already contains 3 TN1650B Memory circuit packs and a V4 or later
TN1657 disk drive, skip to
TN1657 disk drive, skip to
.
The procedures step you through a software and hardware upgrade that can be
done on either a standard reliability system or a high or critical reliability system.
done on either a standard reliability system or a high or critical reliability system.
For more help refer to the following books:
— DEFINITY Enterprise Communications Server Release 8 Administrator’s
Guide
— DEFINITY Enterprise Communications Server Release 8 Maintenance for
R8r