Справочник Пользователя для Perle Systems 5500161-40

Setting Up Printers

338 

IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0

Next you need to create a gateway and destination route entry. Select 

, 

, and 

the 

 tab. 

For the destination, if you want the connection to be able to reach any host in the remote 
network, set the 

 to 

 and specify the network IP address and subnet/prefix bits; if 

you want the connection to go directly to a specific remote host, set the 

 to 

 and specify 

the host’s IP address.

We want a specific host to the be destination, so we configured the 

 as 

:

We also need to create a 

 entry using the same PPP IPv4 local IP address. Any traffic 

that goes through the gateway will automatically cause PPP to dial out:

The IOLAN can communicate with printers on its serial ports using LPD and RCP protocols, as well 
as print handling software using TCP/IP.

When setting up a serial line that access a printer using LPD, do the following:

Set the serial port to 

 and configure the 

, 

 

, 

, 

, and 

 

parameters so that they match the printer’s port settings. 

Save your settings and restart the serial port.

Verify that LPD has been configured on the network host. To configure LPD on the network 
host, you need to know the name or IP address of the IOLAN and the print queue, either 

raw_p<port_number>

 for a raw data connection or 

ascii_p<portnumber>

 for an ASCII 

character connection. You can optionally append 

 or 

to the queue name to add a 

 or 

 to the end of the print job.