Справочник Пользователя для Fujitsu FI-5650C

2-4

When using the scanner with the SCSI inter-
face, you need to purchase a commercially 
available SCSI cable and a SCSI card.

SCSI cable
The SCSI has to fit to a 50 Pin half pitch connector 
and the SCSI card connector of your PC.

SCSI card
Use the recommended SCSI card noted on the fol-
lowing website:
http://imagescanner.fujitsu.com/          

  

 

  

The factory default setting for SCSI ID is "ID 5". If the 
SCSI ID of another device has already been set to the 
same ID, change either the scanner's SCSI ID or that of 
the other device. To change the SCSI ID see the 

following procedure.   

     

2.3 Installing the Scanner 

Application

For scanning documents with this scanner, the 
scanner driver as well as an image capturing 
application software (called "application" here-
after) must be installed on your PC.

Scanner driver:
FUJITSU TWAIN 32 Scanner Driver
FUJITSU ISIS Scanner Driver

ATTENTION

When connecting the SCSI interface 
cable, be sure to first connect the SCSI 
interface cable then turn on the scanner 
and your PC. Connect the scanner so 
that it is the terminated device on the 
SCSI daisy chain.

1.

Open the cable cover located below the 
ADF paper chute,  connect the SCSI cable 
to the SCSI interface connector and make 
sure it is firmly connected.   

Once the cable is connected, close the 
cable cover.

ATTENTION

Be careful not to bend the pins of the 
SCSI cable when connecting to the 
scanner .

2.

HINT

For setting the SCSI ID of the scanner, 
please refer to the following section.

1.

2.

Open the cable cover located below the 
ADF paper chute and set the device 
address by using the SCSI ID switch.  

0 - 7

Can be set as the ID.

8, 9

Used for the factory default value 

(SCSI ID=5).

3.

When the scanner is turned ON, the SCSI 
ID set at step 2 is enabled.

4.

6

5

4

3

2

1

0

7

2

3

4

5

6

7

8

9

0

1