Справочник Пользователя для Panasonic FZ-A1
8
Regulatory Information
This
opera
FCC
the fr
the p
Mobi
alloca
and 5
can c
produ
opera
FCC
the fr
the p
Mobi
alloca
and 5
can c
produ
Resp
Amer
One
Seca
Tel N
Amer
One
Seca
Tel N
USA
com
For
visit
http
or c
com
For
visit
http
or c
CAU
Risk
Inco
Disp
Instr
Risk
Inco
Disp
Instr
ATT
Il y a
rem
Mett
conf
Il y a
rem
Mett
conf
L’ap
alim
Pou
de la
1-80
alim
Pou
de la
1-80
emergency calls. Remember, in order
to make or receive calls, Computer
incorporating wireless WAN modem
must be switched on and in a coverage
area with adequate cellular signal
strength. Some networks do not allow
for emergency calls if certain network
services or phone features are in
use (e.g. lock functions, fixed dialing
etc.). You may need to deactivate
those features before you can make
an emergency call. Some networks
require that a valid SIM card be properly
inserted in Computer incorporating
wireless WAN modem.
to make or receive calls, Computer
incorporating wireless WAN modem
must be switched on and in a coverage
area with adequate cellular signal
strength. Some networks do not allow
for emergency calls if certain network
services or phone features are in
use (e.g. lock functions, fixed dialing
etc.). You may need to deactivate
those features before you can make
an emergency call. Some networks
require that a valid SIM card be properly
inserted in Computer incorporating
wireless WAN modem.
Camera Light
CAUTION
Camera Light for rear camera
- The light from the LED is strong and can injure
- The light from the LED is strong and can injure
human eyes. Do not look directly at the LEDs with
naked eyes.
naked eyes.
57-E-1
For U.S.A.
<Models for U.S.A.>
Federal Communications Commission Radio
Frequency Interference Statement
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
Federal Communications Commission Radio
Frequency Interference Statement
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
circuit different from that to which the receiver is
connected.
Consult the Panasonic Service Center or an
experienced radio/TV technician for help.
experienced radio/TV technician for help.
Warning
To assure continued compliance, use only shielded
interface cables when connecting to a computer
or peripheral. Also, any changes or modifications
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate this equipment.
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful
To assure continued compliance, use only shielded
interface cables when connecting to a computer
or peripheral. Also, any changes or modifications
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate this equipment.
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
undesired operation.
FCC RF Exposure Warning:
This device meets the government’s
requirements for exposure to radio waves.
This device is designed and manufactured not
to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal
Communications Commission of the U.S.
Government.
requirements for exposure to radio waves.
This device is designed and manufactured not
to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal
Communications Commission of the U.S.
Government.
This equipment has been approved for portable
operation, and does not require any minimum
spacing be provided between antennas and
all person’s body. This equipment may not be
colocated or operated with any other antenna or
transmitter.
operation, and does not require any minimum
spacing be provided between antennas and
all person’s body. This equipment may not be
colocated or operated with any other antenna or
transmitter.
The exposure standard for wireless device
employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit
set by the FCC is 1.6 W/kg.
* Tests for SAR are conducted using standard
employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit
set by the FCC is 1.6 W/kg.
* Tests for SAR are conducted using standard
operating positions accepted by the FCC with
the device transmitting at its highest certified
power level in all tested frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR level of
the device while operating can be well below
the maximum value. This is because the
device is designed to operate at multiple power
levels so as to use only the poser required to
reach the network. In general, the closer you
are to a wireless base station antenna, the
lower the power output.
the device transmitting at its highest certified
power level in all tested frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR level of
the device while operating can be well below
the maximum value. This is because the
device is designed to operate at multiple power
levels so as to use only the poser required to
reach the network. In general, the closer you
are to a wireless base station antenna, the
lower the power output.
The FCC has granted an Equipment
Authorization for this device with all reported
SAR levels evaluated as in compliance with the
FCC RF exposure guidelines. SAR information
on this device is on file with the FCC and can be
found under the Display Grant section of www.
fcc.gov/oet/ea/fccid after searching on FCC ID:
ACJ9TGFZ-A12.
Authorization for this device with all reported
SAR levels evaluated as in compliance with the
FCC RF exposure guidelines. SAR information
on this device is on file with the FCC and can be
found under the Display Grant section of www.
fcc.gov/oet/ea/fccid after searching on FCC ID:
ACJ9TGFZ-A12.
25-M-4
Read Me First