Справочник Пользователя для Pelco C1445M-E (2/09)

6

C1445M-E (2/09)

To install the pressure sensor:

1. Remove the screw located inside the top portion of the enclosure’s rear plate (refer to Figure 2). 

Insert the pressure sensor tube fitting into the hole.

2. Loosen the camera sled mounting screws (refer to Figure 2). Slide the sensor bracket under the 

mounting screws and ground lug. Tighten the screws. 

3. Connect the wire leads (refer to Figure 2 and Figure 3 on page 7):

a.

Green/white wire: Insert the push-on lug into the connector on the pressure sensor 
assembly. Connect the spade lug to the power terminal block under the AC NEUT wire. 

b.

White/green wire: Insert the push-on lug into the connector on the pressure sensor 
assembly. Connect the spade lug to the power terminal block above the AC LINE wire.

Figure 2. EH8100 Series Enclosure: Rear Plate, Inside View

GROUND STUD

REMOVE
SCREW

INSERT TUBE
FITTING

WHITE/GREEN
WIRE

GREEN/WHITE
WIRE

SLIDE SENSOR BRACKET
UNDER MOUNTING SCREWS
AND GROUND STUD

CAMERA SLED