Инструкции Пользователя для Bose PDF259774_00
PDF259774_00
April 12, 2001
11
System Setup
Figure 7
Example 2: Wave/PC
™
system connections
Connecting the power cord to the Wave/PC unit
1.
Plug the small end of the power cord into the power jack on the back of your Wave/PC
unit (Figure 8). The connector is shaped to fit in only one direction. Line up the flat edge of
the plug with the flat edge on the side of the jack.
unit (Figure 8). The connector is shaped to fit in only one direction. Line up the flat edge of
the plug with the flat edge on the side of the jack.
2.
Connect the other end of the power cord to an AC (mains) outlet. The clock time display
should begin flashing. The flashing will stop during software installation when the clock is
set by your computer.
should begin flashing. The flashing will stop during software installation when the clock is
set by your computer.
Figure 8
Connecting the power cord
Audio plug
Serial data
port (DB9)
connector
connector
Audio
output
jack
Serial data
port
DIN socket
DIN connector
Wave/PC system cable
Rear panel of computer