Инструкции Пользователя для Bose PDF259774_00

If you need additional help in solving problems, contact:

You can also request technical support using the Wave/PC

™

 system application. Click the 

Setup button and click on the Internet tab. Click the Tech Support button and follow the 
instructions.

Wave/PC system unit does not 
function

• Make sure the power cord connector is inserted securely into the Wave/PC 

unit, matching the flat side of the connector to the flat side of the jack.

• Make sure the power cord is fully plugged into an operating AC wall outlet.

Remote control is inconsistent or does 
not work

• Check battery and its polarity (+ and –).
• Replace the battery, if necessary (See “Replacing the batteries” on 

• Operate the remote control closer to the radio.
• Check for interference from room lighting or sunlight, or dust or dirt on the 

lens. Try the radio in a different location.

AM/FM stations play OK, but no audio 
for CDs, Web Radio, or Music Files. 
No computer tones. 

• Check the interface cable connection between your computer and the 

Wave/PC system unit.

• Close all other programs that use the serial port.
• Close the Wave/PC monitor and launch the Wave/PC application again.
• Click the Setup button and click on the General tab. Click the Search for 

Wave/PC button.

• Save all your work and restart your computer. If problem still persists, con-

tact Bose Customer Service.

A yellow question mark appears over 
the Wave/PC system monitor icon in 
the Task Bar.

No audio from my computer and the 
Wave/PC monitor icon in the Task Bar 
appears normal.

• Check the audio connection to the sound card of your computer.
• Check the volume calibration. Click the Setup button and click on the Gen-

eral tab. Click the Calibrate Volume Control button.

• If you are using a portable computer, or any computer with a dial-type vol-

ume control, make sure the volume level is set to maximum.

Other music sources are heard when 
listening to AM/FM radio.

Switch to another source and then return to AM/FM radio. A Wave/PC system 
command may have been ignored while the computer was busy with other 
activities.

No audio after launching application. 

Re-calibrate the Wave/PC system volume:

1.

Click the Setup button and click on the General tab.

2.

Click the Calibrate Volume Control button.

3.

Wait for the process to complete

4.

Click the OK button.

The volume control of the computer is 
reset every time the application is 
launched.

The computer audio is much louder/
softer than AM/FM radio audio.

The display on the Wave/PC

™

 unit 

sometimes flashes “no PC” or “PC.

Wait. The computer may be busy performing other tasks. This problem should 
disappear after the computer returns to normal operation. If not, contact Cus-
tomer Service.

The time displayed on Wave/PC unit is 
incorrect.

Adjust the time of the clock in your computer. By default, the Wave/PC applica-
tion synchronizes the Wave/PC system clock to the clock in your computer. If 
you want to set the Wave/PC system clock independently, click the Setup but-
ton and click the General tab. Disable the clock synchronization option.