Справочник Пользователя для SMART Technologies D600i4

CHAPTER 7 – REPLACING THE SMART UF65 OR SMART UF65W PROJECTOR 
LAMP

 

Resetting the Lamp Timer

After you replace the lamp, you need to access the projector service menu and reset 
the lamp hour counter. To prevent accidental errors, only a system administrator 
should perform this procedure.

NOTE
Always reset the Lamp Hours after you exchange a lamp. Lamp service reminders 
are based on the current hours of use.

1. Using the remote control, press the following buttons quickly to access the service 

menu: Down, Up, Up, Left, Up.

CAUTION
Do not adjust any settings in the service menu other than those listed in this 
procedure. Changing other settings might damage or affect the operation of 
your projector and will invalidate your warranty.

2. Scroll down to the Lamp Hour Reset field, and then press OK.

Both Lamp Hour values (Standard and Economy) are reset to zero.

CAUTION
Do not use the Lamp Hour Reset feature unless you have just replaced the 
lamp. Resetting the lamp hour counter on an old lamp might damage your 
projector due to lamp failure.

NOTE
You’re unable to reset the Display Hour value because it’s the running total of 
hours the projector has been in use.

3. Press the Menu button on the remote control.

The SMART UF65 Settings menu appears.

4. Select 

 to confirm that Lamp Hours has been reset to zero.

Your system is ready for use.