Справочник Пользователя для SMART Technologies D600i4
42 |
CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
SYSTEM
Projector Programming Commands
Projector Powerstate Controls
The SMART UF65 or SMART UF65w projector responds to commands only at certain
power levels and times. There are five projector power states:
power levels and times. There are five projector power states:
•
Powering (startup)
•
On (operating)
•
Cooling
•
Confirm off
•
Idle
Command Inventory
The SMART UF65 or SMART UF65w projector responds to the commands in the
tables on the following pages. To see a list of valid commands in the projector’s
current power state, type “?” and press ENTER.
tables on the following pages. To see a list of valid commands in the projector’s
current power state, type “?” and press ENTER.
NOTES
•
•
Send a command after the projector sends a command prompt.
•
Commands aren’t case sensitive. Type commands exactly as they appear in
the left column of the tables, with the proper value or setting in the center
column.
the left column of the tables, with the proper value or setting in the center
column.
•
Check your entries carefully before entering your commands.
•
Press ENTER after typing each command.
•
After the projector executes a command, it generates a response.
•
To avoid buffer overrun, don’t send another command until you receive the
next command prompt.
next command prompt.
Value-Based Command Methods
Absolute Values and Adjustment Values
You can use the command’s target range to set an absolute value for a command, or
cause an adjustment to be made to the current value. To create an adjustment
command, add a plus (+) or minus (-) symbol instead of the equal symbol (=) before
the value change you want to enter. All absolute values you enter must be within the
command target range, and all adjustment values must equal a number within the
command target range.
You can use the command’s target range to set an absolute value for a command, or
cause an adjustment to be made to the current value. To create an adjustment
command, add a plus (+) or minus (-) symbol instead of the equal symbol (=) before
the value change you want to enter. All absolute values you enter must be within the
command target range, and all adjustment values must equal a number within the
command target range.