Справочник Пользователя для SMART Technologies D600i4

 

CHAPTER 5 – TROUBLESHOOTING YOUR INTERACTIVE WHITEBOARD 
SYSTEM

No Projected Image
If the projector displays no image at all, and the ECP, interactive whiteboard and 
projector power lights aren’t on, perform the following procedure.

1. Ensure that the power cord is connected to the power outlet.

2. Ensure that your cables are correctly and securely connected as described in the 

included 

.

3. Check the power cable and VGA connector pins to make sure they aren’t bent 

or broken.

4. Ensure that the projector lamp is securely installed.

5. Confirm that your projector is turned on and that the projector status lights are 

illuminated. If the projector displays unusual status light behavior, see Projector 
Ready Lights and Projector Status on page 66 to troubleshoot your system.

NOTES
•

The following procedure applies to Windows 95, Windows 98, Windows 2000 
and Windows XP operating systems on desktop computers only.

•

This procedure may vary depending on your version of Windows operating 
system and your system preferences.

1. Select Start > Control Panel.

2. Double-click Display.

The Display Properties window appears.

3. Click Settings.

4. Verify that your display resolution setting is lower than or equal to 1024 × 768 

(SMART UF65 projector) or 1280 × 800 (SMART UF65w projector).

IMPORTANT
If the projector still does not display the entire image, perform the following 
procedure to change the monitor display.