Справочник Пользователя для Beko GNE 60520 DX

Скачать
Страница из 35
EN
15
The water filter must be removed as 
shown in the figure when it is going to 
be replaced or when it will no longer 
be used and by-pass cover must be 
attached. It must be made sure that 
Ice Off mode is active before taking it 
out.
A
 Caution: Water filter cleans some 
foreign particles in the water. It does 
not purify water from microorganisms.
A
 Caution: Ice Off button must always 
be pressed during replacement of the 
water filter or installing the by-pass 
cover.
Prior to first use of Water 
Dispenser
C
 Water mains pressure must not be 
below 100 kpa.
C
 Water mains pressure must not be 
above 800 kpa.
C
 Pumps must be used in case the 
supply water pressure drops below 1 
bar or if a bottle is going to be used.
C
 Water system of the refrigerator 
must be connected to the cold water 
line. It must not be connected to hot 
water line.
C
 No water may be obtained in the 
initial operation of the refrigerator. This 
is caused by the air in the system. To 
discharge air from the system, press 
Dispenser latch for periods of 1 minute 
until water comes from the Dispenser.  
Water flow may be irregular in the 
beginning. Irregular water flow will be 
normalized after the air in the system is 
discharged.
C
 At the initial startup of the 
refrigerator approx.12 hours must pass 
before cold water can be obtained.
C
 Water mains pressure must be 
between 1-8 bars for the operation 
of Ice/Water Dispenser smoothly. For 
this, check that 1 glass of water (100 
cc) can be filled in 10 seconds.
C
 The first 10 glasses of water should 
not be consumed.
C
 Approximately the first 30 cubes 
of ice to be obtained from the Ice 
Dispenser must not be used. 
C
 Always use the water filter when a 
bottle is not being used.