Справочник Пользователя для ZyXEL Access Point G1000 v2 91-005-124001B
Модели
91-005-124001B
ZyXEL G-1000 v2 User’s Guide
62
Chapter 4 Wireless LAN
The following table describes the labels in this screen.
Table 22 Wireless LAN: Advanced
LABEL
DESCRIPTION
Roaming Configuration
Enable
Roaming
Select this checkbox to enable roaming on the G-1000 v2 if you have two or more G-
1000 v2s on the same subnet.
Note: All APs on the same subnet and the wireless stations must
have the same SSID to allow roaming.
Port
Enter the port number to communicate roaming information between APs. The port
number must be the same on all APs. The default is 3517. Make sure this port is not
used by other services.
Wireless Advanced Setup
RTS/CTS
Threshold
Enter a value between 0 and 2432. If you select the Enable 802.11g+ mode
checkbox, this field is grayed out and the G-1000 v2 uses 4096 automatically.
Fragmentation
Threshold
It is the maximum data fragment size that can be sent. Enter a value between 256 and
2432. If you select the Enable 802.11g+ mode checkbox, this field is grayed out and
the G-1000 v2 uses 4096 automatically.
Enable Intra-
BSS Traffic
Intra-BSS traffic is traffic between wireless stations in the BSS (Basic Service Set).
Select this check box to enable Intra-BSS Traffic.
Enable
Breathing LED
Select this check box to enable the Breathing LED, also known as the
ZyAIR
LED.
The blue ZyAIR LED is on when the G-1000 v2 is on and blinks (or breaths) when
data is being transmitted to/from its wireless stations.
Clear the check box to turn this LED off even when the G-1000 v2 is on and data is
Clear the check box to turn this LED off even when the G-1000 v2 is on and data is
being transmitted/received.
Number of
Wireless
Stations
Allowed
Enter a number from 1 to 32, to limit the number of wireless devices which can
communicate in your wireless network.
802.11 Mode
Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to
associate with the G-1000 v2.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
associate with the G-1000 v2.
Select Mixed to allow either IEEE802.11b or IEEE802.11g compliant WLAN devices
Select Mixed to allow either IEEE802.11b or IEEE802.11g compliant WLAN devices
to associate with the G-1000 v2. The transmission rate of your G-1000 v2 might be
reduced.
Apply
Click Apply to save your changes back to the G-1000 v2.
Reset
Click Reset to reload the previous configuration for this screen.