Справочник Пользователя для Tandberg Data T40

 

50  

Running the Library 

The following illustration shows the correct way to remove the magazine from its bay.  

 Note 

You cannot remove the magazine if the unit is password protected or locked by 
host software through a Prevent Medium Removal SCSI command.  

When ejecting the magazine it automatically pops out a few inches. With one hand, grip the handle on 
the outer side of the magazine bezel and hold the other hand under the magazine. Pull the magazine 
carefully out and keep it in level with the library. If the magazine is filled with cartridges, be aware of 
the weight of the magazine. Keep one hand underneath the magazine to prevent the back of the 
magazine to fall down when it leaves the magazine bay. See 

Figure 18. Removing the Magazine from

 

the Library.

  

Figure 18. Removing the Magazine from the Library 

  

When inserting cartridges, the access door of the cartridge must face the magazine slot opening. 
Push the cartridge carefully into the magazine slot until it locks in place. The rear side of the cartridge 
with the Write Protect switch and the barcode label must face out. Make sure the cartridges latch 
properly.  

Figure 19. Gently Push the Cartridge into the Magazine Slot 

   

Press the cartridge release tab towards the cartridge until the cartridge is released. The cartridge is 
spring loaded, so it is important to prevent the cartridge from popping all the way out.