Справочник Пользователя для Multiquip CD613H18 (Honda GX390 Gasoline Engine)
STOW CUTTER 1 SAW — OPERATION & PARTS MANUAL — REV. #6 (06/06/08) — PAGE 13
STOW CUTTER 1 SAW — CONTROLS & COMPONENTS
Figure 3 shows the location of the basic controls or components
for the STOW CUTTER 1 SAW. Listed below is a brief
explanation of each control or component. (Gasoline-powered
unit shown)
for the STOW CUTTER 1 SAW. Listed below is a brief
explanation of each control or component. (Gasoline-powered
unit shown)
1.
Hand Grips/Handlebar – When operating the saw, place
both hands on each grip to maneuver the saw. Replace
hand grips when they become worn or damaged.
both hands on each grip to maneuver the saw. Replace
hand grips when they become worn or damaged.
2.
Handle Lock – Lock blade depth to desired position.
3.
Garden Hose Connecter – Connect to water source to
provide blade cooling while cutting concrete or asphalt.
provide blade cooling while cutting concrete or asphalt.
4.
Air Filter – Prevents dirt and debris from entering the engine
air intake. Check filter periodically and keep cleaned or
replace when necessary.
air intake. Check filter periodically and keep cleaned or
replace when necessary.
5.
Recoil Starter Handle – Pull to engage and start the
engine.
engine.
6.
Recoil Starter Assembly – Engages the engine when
the handle is pulled and rewinds the starter rope when the
handle is released.
the handle is pulled and rewinds the starter rope when the
handle is released.
7.
Wheels/Carriage Assembly – Heavy-duty polyurethane
wheels with permanently sealed ball bearings.
wheels with permanently sealed ball bearings.
CONTROLS & COMPONENTS
Figure 3. Cutter 1
8.
Cutting Blade – Use appropriate type blades for cutting
concrete or asphalt.
concrete or asphalt.
9.
Blade Guard – Covers saw blade and flips up to allow
blade to be changed.
blade to be changed.
10. Belt Tension Adjuster – Adjusts belt tension.
11. Front Pointer – Front pointer wheel assists in straight
tracking.
12. Front Pointer Arm – Stows up for storage and pivots down
for use.
13. Cutting Depth Adjuster – turn operating crank clockwise
or counter-clockwise to adjust the cutting depth up or down.
14. Fuel Tank – Use unleaded gasoline. Do not overfill.
15. Blade Coolant System – Provides cooling water to blade
during cutting operations.
16. V-Belt Cover – Remove this cover to gain access to the V-
belt. NEVER operate the saw with this cover removed.
17. Arbor Shaft Grease Zerks – Conveniently located for
lubrication.
18. On/Off Switch – Turn to the "ON" position to allow engine
to be started and turn to the "OFF" position to shut the
engine off.
engine off.