Справочник Пользователя для Southbend sb1018

-30-

For Machines Mfg. Since 8/09

Model SB1018

Remove the two spacers from the holes 

on the left side of the machine base, then 

reposition them into the two holes in the 

right side of the machine base, as shown in 

Figure 39.

Place the vise over the spacers, aligning it 

so it sits flush on the machine base, then 

use the two cap screws removed in Step 2 to 

secure the vise to the base.

6.  Loosen the lock handle shown in Figure 

38, then swivel the headstock to the desired 

angle, using the angle scale as a guide.

7.  Move the saw through its full range of 

motion to make sure the blade will not 

contact the vise during operation, then 

tighten the swivel lock handle.

Figure 40 shows the correct methods for holding 

different workpiece shapes.

If  you  need  to  make  a  cut  from  45°  to  60°,  you 

will have to make the cut to the left, which will 

require  moving  the  vise  to  the  right  side  of  the 

machine.

1.  DISCONNECT BANDSAW FROM POWER!

2.  Support the vise with one hand and remove 

the two cap screws that secure the vise to the 

machine base, then set the vise aside.

3.  Lift the headstock to the upmost position, 

then close the downfeed valve to prevent it 

from lowering.