Справочник Пользователя для Southbend sb1018

-36-

For Machines Mfg. Since 8/09

Model SB1018

If the blade stops moving while the motor is still 

running, the V-belt may be slipping and will 

need to be tightened.

If the V-belt shows signs of excessive wear, such 

as cracking or fraying, it must be replaced.

1.  DISCONNECT BANDSAW FROM POWER!

2.  Open the belt cover, then loosen the belt 

tension bolt shown in Figure 49 to allow the 

motor to pivot.

1.  DISCONNECT BANDSAW FROM POWER!

2.  Open the belt cover, then loosen the belt 

tension bolt shown in Figure 49 to allow the 

motor to pivot.

3.  Lift the motor to relieve the belt tension, 

then remove the belt.

4.  Install a new belt, then release the motor 

and let its weight tension the belt.

5.  Re-tighten the belt tension bolt and close the 

belt cover.

3.  Release the motor and let its weight tension 

the belt. If necessary, apply downward 

pressure to the motor to further tighten 

the belt. When properly tensioned, the 

belt should deflect approximately ¼" when 

pressed with moderate pressure, as shown in 

Figure 50.