Справочник Пользователя для Southbend sb1018

-42-

For Machines Mfg. Since 8/09

Model SB1018

5.  Close the motor junction box and secure the 

cover with the provided screw.

6.  Use the 18mm wrench to remove the four 

hex bolts that secure the machine to the 

cabinet, then with the help of another per-

son, remove the machine from the cabinet. 

Carefully place the machine on its side to 

gain access to the underside of the base.

7.  Remove the black plastic switch cover from 

behind the switch. Disconnect the two wires 

from the back of the switch, then remove the 

switch.

8.  Install the 220V switch, then replace the two 

wires removed in Step 7 in the correspond-

ing locations from which they were removed.

9.  Replace the switch cover, then with the help 

of another person, place the machine back 

onto the cabinet and secure it with the hex 

bolts removed in Step 6.

3.  Use a wire nut to connect wires #2, #3, and 

#5, then wrap the wires and nuts with elec-

trical tape.

4.  Connect wires #1 and #6 to the upper right 

terminal and wire #4 to the lower right 

terminal shown in Figure 54. Tighten the 

terminal screws to secure the wires.

6

1

4

5

2

3

6

1

4

5

2

3

GND

1

2

3

4

1

2

3

4

220V Switch (Part No. PSB1018204) ...................1

Phillips Screwdriver #2 ........................................1

Wrench 18mm .......................................................1

Wire nut (sized for three 14 Ga. wires) ................1

Electrical Tape .......................................As needed

Wire stripper ..........................................As needed

1.  DISCONNECT BANDSAW FROM POWER!

2.  Open the motor junction box, then loosen the 

wire terminals indicated in Figure 53. Re-

move the wires connected to those terminals.

6

1

4

5

2

3

6

1

4

5

2

3

GND

1

2

3

4

1

2

3

4

Wiring diagrams are provided in this section 

showing the Model SB1018 wired for both 110V 

and 220V. Refer to these diagrams if needed 

when following this procedure. Additionally, 

you must purchase a 220V switch (Part 

No. PSB1018204) in order to complete the 

conversion.