Справочник Пользователя для Ingersoll-Rand 4581740

04581740_ed2 

23

 

When Tube Nut 1 is selected, the spindle operates in tube nut reverse when the momentary position of the 

switch is activated. No trigger press is necessary to operate the spindle in tube nut reverse in this mode. When the 

momentary switch is released, the spindle stops, and it is then ready for forward operation.

 

When Tube Nut 2 is selected, tube nut reverse requires the activation of both the momentary switch and the 

trigger. In other words, this mode requires 2-handed operation by the user. If the trigger is released and the 

momentary switch is not released, the spindle remains ready to operate in tube nut reverse with the press of the 

trigger. If the momentary switch is released but the trigger is not, the spindle remains stopped until the trigger 

is also pressed. When both the momentary switch and the trigger are released, the spindle returns to forward 

operation and is ready to accept a trigger press for running forward.

 

When Gang Advance is selected and momentary position of the switch is activated, the gang count is incremented 

by 1 for the failed cycle. 

 

When Gang Reset is selected and momentary position of the switch is activated, the gang count is reset 1.

 

When Config Reset is selected and momentary position of the switch is activated, the configuration is reset to the 

configuration programmed in the engage step of “Reset to”.

 

When Tube Nut 3 is selected, the spindle operates in tube nut reverse when the momentary position of the switch 

is reverse direction and trigger is pulled.

 

The final parameter that you can set on this screen is TactAlert. This parameter is set to either Disable or Enable. 

When set to Enable, the spindle vibrates at the end of a failed cycle.

To reset the Transducer Range (TR) or Angle Scale Constant (ASC) back to their factory-set values, choose the 

appropriate button from the right side of the Spindle Setup screen and press Enter. 

To reset the Transducer Range (TR) or Angle Scale Constant 

(ASC) back to their factory-set values, choose the appropriate 

button from the right side of the Spindle Setup screen and 

press Enter.

Autocal or Auto calibration allows you to calibrate the Transducer Range (TR) for Insight spindles using an  

Ingersoll Rand ETA series external torque transducer. You can set up Autocal by connecting a PC to the controller 

through the Ethernet port, and connecting the ETA to the PC via its serial port. The data received from the ETA during a 

series of cycles helps to refine the TR value. 

On the Setup menu’s Serial Settings sub-menu screen, you can select the serial communications parameters assigned 

to the serial port. These parameters are set based on the communications requirements of the serial device that is being 

connected to the Insight controller.

This parameter sets the communications protocol. Use the dropdown list in Protocol parameter to set it to None or 

E.O.R. Data Out.  Other protocols are available through the ICS software.  If one of these protocols is selected then the 

dropbox becomes disabled and will display the protocol selected.  Only the ICS software can change the protocol once 

the dropbox has been disabled.

This sets the speed of communications for the serial port. Select a Baud Rate from the dropdown list in the range 1,200 

to 115,200.

Select the Parity for the serial connection to None, Odd, or Even from the drop box list.

Use the dropdown list to set the Bits Per Character parameter to 7 or 8.

The # of Stop Bits for serial port communications is set to indicate 1 or 2 stop bits with the dropdown list found in this 

parameter.