Справочник Пользователя для Hitachi C 10RB

–  12  – 

NOTE: Make sure the “anti-kick back pawls do not get 
caught between the insert and the guard, but rest on top 
of the insert. 

1.  Remove the table insert.
2.  With the blade elevation handwheel (1), raise the 

blade to the maximum height.

3.  Loosen blade lock handle (2) do not pull on handle 

just turn and move the handwheel (1) to 45° on the 
bevel scale.

4.  Tighten the bevel lock handle.
5.  Cover the blade teeth with a piece of folded 

cardboard or position the plastic blade guard over the 
blade to protect your hands.

6.  Loosen the nut (5) and remove the blade guard 

assembly, then retighten the nut. 

7.  Return the blade to 90° and replace the table insert.

NOTE: When took off the insert, and rise the blade, kick 
back pawl will snap in the hole on the table and can not 
take off. Make sure the insert is assembled before rising 
the blade. 

•  When installing the blade guard, cover the blade 

teeth with a piece of folded cardboard to protect 
yourself from possible injury.

•  Never operate this machine without the safety guard 

in place for all through sawing operations.

IMPORTANT: The splitter must always be correctly 
aligned with the blade so the cut workpiece will pass on 
either side without binding or twisting. 

1.  Remove the table insert and raise the blade to the 

maximum height by turning the blade elevation 
handwheel clockwise.

2.  Lift the blade guard and position it toward the rear of 

the table.

3.  Adjust the blade to the 90° vertical position by 

unlocking the blade tilting lock knob and turning the 
bevel tilting handwheel counterclockwise, and then 
lock into position.

4.  To see if the blade (1) and splitter (2) are correctly 

aligned, lay a combination square along the side of 
the blade and against the splitter (making sure the 
square is between the teeth of the blade).

5.  Tilt the blade to the 45° position and check the 

alignment again.

6.  If the blade and splitter are not correctly aligned:

a.  Remove the blade guard by removing the  
    wing bolt that locks the guard in place.
b.  Loosen and remove the two bolts (3) from the 

mounting bracket (5).

7.  Place two spacers (4) on the guard mounting bracket 

(attached to the saw).  Position them over the 
corresponding mounting bolt holes (refer to step 6-b) 
after removing the adhesive backing affixed to the 
washers.

8.  Replace the two guard mounting bolts (3) and tighten 

securely. Also reattach the blade guard assembly, 
affixing it to the machine by its’ corresponding wing 
bolt. 

9.  Check the splitter and blade alignment again at both 

90° and 45°.

10.Add or remove the spacers until the alignment is 

correct.

11.Replace the table insert.

        

1

2

3

5

4

1

2

3

4

5