Справочник Пользователя для Black & Decker BPSC2135

•  A spacer block slightly narrower than the work piece can 

be used to increase wheel utilization (Fig. 2).

•  Long work pieces must be supported by a block so it will 

be level with top of base (Fig. 3). The cut off end should 
be free to fall downward to avoid wheel binding.

The vise (F) has a quick-travel feature. To release the vise 

when it is clamped tightly, turn the crank (H) 
counterclockwise one or two times to remove clamping 
pressure. Lift vise lever (I) up. Pull crank assembly out as 
far asdesired. Vise may be pushed forward into work without 
cranking. Lower vise lever (I) then tighten vise (F) onwork by 
using crank (H).

sure the trigger switch is in the OFF position.The fence 
(E) can be adjusted two ways: to change desired cutting 
angle and to change spacing between the fence and vise.

Use the wrench provided to loosen (do not remove) the two 
fence bolts (P). Align the desired angle indicator line with 
theslot line (A) in the base (D). Securely tighten both fence 
bolts before use. For more accurate square cuts, disconnect 
the power supply, loosen the two fence bolts, push arm 
down until wheel extends into base. Place a square against 
thewheel and adjust fence against the square. Securely 
tighten both fence bolts before use. When making a miter 
cut, thevise (F) may not clamp securely, depending on the 
thickness of the workpiece and the miter angle. Other aids 
(such as spring, bar or C-clamps) will be necessary to 
secure the work piece to the fence when making these cuts.

Using the wrench provided, loosen and remove the two 
fence bolts (P). Adjust the fence (E) to desired 
locations.Insert both fence bolts in provided locations. 
Securely tighten both fence bolts before use.

sure the trigger switch is in the OFF position. Do not 

make any adjustment while the wheel is in motion. Do not 

make any adjustment while chop saw is plugged into power 

supply.

1.  Push in spindle lock (L) and rotate wheel (J) by hand 

until wheel lock lever engages slot in inside flange(R) to 

lock wheel. Loosen the bolt (S) counterclockwise in the 

center of the abrasive wheel with the 8mm hex wrench 

(G). Bolt has right-hand thread.

2.  Remove the bolt (S), washer (T), outside flange (U) and 

old wheel (J).

3.  Make sure flange surfaces are clean and flat. Install the 

new abrasive wheel by reversing the above steps.

4.  Do not overtighten bolt.

Warning: Check the work surface that the chop 

saw rests on when replacing with a new abrasive 

wheel. Itis possible that the wheel may contact 

ANY ITEMS OR STRUCTURE THAT EXTENDS ABOVE 

work surface (under the base) when the arm is fully lowered.

•  Allow the wheel to do the cutting. Excessive force will 

cause the wheel to glaze reducing cutting efficiency 

and/or to deflect causing inaccurate cuts.

•  Properly adjust fence angle.

•  Make sure material is laying flat across base.

•  Properly clamp material to avoid movement and 

vibration.

the trigger switch is in the OFF position. 

Brushes should be regularly inspected for wear. 

To inspect brushes, unscrew the two end cap screws (V) and 

remove end cap (W). Remove brush cap (Y). Brushes (X) 

should slide freely in brush box. If brushes are worndown to 

.3"