Справочник Пользователя для Bosch 3918

adjustments, changing accessories, or storing the tool.
Such preventive safety measures reduce the risk of starting
the tool accidentally.

NOTE:  Your compound miter saw was completely adjusted
at the factory.  However, during shipment, slight misalignment
may have occurred.  Check the following settings and adjust
if necessary prior to using this compound miter saw.

1.

Rotate table 

1 to 0° position and lock in place.

2.

Lower the blade 

2 and engage the lock pin 3. Use a

combination square 

4 to check blade squareness to

table.  Place the square on the table and press it against
the blade. If the blade does not contact the full length of
the square, (Figure 6) follow the alignment procedure.

a.

Move sliding fence to proper position. (See Sliding
Fence on page 54.)

b.

Loosen bevel lock handle 

5.

c.

Loosen jam nut 

6 using blade wrench supplied in

the handle, and lower 0° stop screw 

7 with the

3 mm hex wrench provided.

d.

Grasp carrying handle, move the head assembly
left or right until blade makes contact with the full
length of the square.

e.

Tighten bevel lock handle 

5.

f.

Adjust 0° stop screw 

7 so that the hex screw head

hits the 0° stop at the same time the blade makes
contact with the full length of the square. Tighten
jam nut 

6 (Figure 7).