Справочник Пользователя для Graco Inc. 288046
Installation
8
311052E
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod [0.5 in. (13
mm) diameter maximum]:
mm) diameter maximum]:
1.
Insert the mounting bar (A) through the hole in the
manifold as shown in F
manifold as shown in F
. 3.
2.
Secure the gun to the bar by tightening the mount-
ing screw (B).
ing screw (B).
Stationary Support
To mount the gun on a stationary support (refer to F
1.
Align the manifold with the alignment pins. Locate
alignment pins and holes per the Mounting Hole
Layout illustration, page 37.
alignment pins and holes per the Mounting Hole
Layout illustration, page 37.
2.
Secure the gun to the support with two M5 x 0.8
capscrews (S). The screws must be long enough to
engage the threaded holes in the gun manifold to a
depth of 1/4 in. (6 mm).
capscrews (S). The screws must be long enough to
engage the threaded holes in the gun manifold to a
depth of 1/4 in. (6 mm).
Retrofit Adapter Plate
The retrofit adapter plate enables the manifold to be
attached to a variety of bolt patterns.
attached to a variety of bolt patterns.
To mount the gun using the retrofit adapter plate (kit
288197):
288197):
1.
Mount adapter plate to manifold using the three
screws provided with the kit (F
screws provided with the kit (F
. 5).
2.
Bolt plate to mounting surface using four M5 x 0.8
capscrews. Refer to the Mounting Hole Layout,
page 37.
capscrews. Refer to the Mounting Hole Layout,
page 37.
Use the 1/8 in. alignment pin (P) to assist in orient-
ing the gun.
ing the gun.
F
IG
. 3: Reciprocating Arm Mount
B
A
TI8120a
P
F
IG
. 4: Stationary Support Mount
F
IG
. 5: Retrofit Adapter Plate
S
TI8121a
TI8180a