Справочник Пользователя для Wagner SprayTech HC950 SSP

HC 950 • HC 970

27

 

Safety precautions

•  Follow material and solvent manufacturer’s warnings and

instructions. Be familiar with the coating material’s MSDS

sheet and technical information to ensure safe use.

•  Use lowest possible pressure to flush equipment.

•  When cleaning the unit with solvents, the solvent should

never be sprayed or pumped back into a container with a 

small opening (bunghole). An explosive gas/air mixture can

arise. The container must be earthed.

PREVENTION:

•  Wear respiratory protection when spraying. Read all

instructions supplied with the mask to be sure it will provide 

the necessary protection. 

•  All local regulations regarding protection against hazardous

vapors must be observed.

•  Wear protective eyewear.

•  Protective clothing, gloves and possibly skin protection cream

are necessary for the protection of the skin. Observe the

regulations of the manufacturer concerning coating materials, 

solvents and cleaning agents in preparation, processing and 

cleaning units.

PREVENTION:

•  Follow all appropriate local, state, and national codes

governing ventilation, fire prevention, and operation. 

•  Pulling the trigger causes a recoil force to the hand that is

holding the spray gun. The recoil force of the spray gun is

particularly powerful when the tip has been removed and 

a high pressure has been set on the airless pump. When 

cleaning without a spray tip, set the pressure control knob to 

the lowest pressure.

•  Use only manufacturer authorized parts. User assumes all

risks and liabilities when using parts that do not meet the 

minimum specifications and safety devices of the pump 

manufacturer.

•  ALWAYS follow the material manufacturer’s instructions for

safe handling of paint and solvents.

•  Clean up all material and solvent spills immediately to prevent

slip hazard.

•  Wear ear protection. This unit can produce noise levels above

85 dB(A).

•  Never leave this equipment unattended. Keep away from

children or anyone not familiar with the operation of airless 

equipment.

•  Do not spray on windy days.

•  The device and all related liquids (i.e. hydraulic oil) must be

disposed of in an environmentally friendly way.

Electric models must be earthed.  In the event of an electrical short 

circuit, earthing reduces the risk of electric shock by providing an 

escape wire for the electric current. This product is equipped with

a cord having an earthing wire with an appropriate earthing plug. 

Connection to the mains only through a special feed point, e.g. 

through an error protection insallation with INF < 30 mA.

Danger of short-circuits caused by water ingressing into the electrical 

equipment. Never spray down the unit with high-pressure or high-

pressure steam cleaners.

Work or repairs at the electrical equipment:
These may only be carried out by a skilled electrician. No liability is

assumed for incorrect installation.