Справочник Пользователя для Wagner SprayTech 110v

 

1

2

3

4

STARTUP

1.  Immerse the suction system into a container filled with a 

suitable cleaning agent (recommendation: water).

2.  Fill up hopper with a suitable cleaning agent (recommen-

dation: water).

3.  Set multifunction switch (1) to 

 (ON– circulation); the 

unit commences to run.

4.  Turn the pressure regulating knob (2) to the right until 

the stop is reached.

5.  Wait until cleaning agent is emitted from the return hose.

6.  Turn the pressure regulating knob (2) back approx. one 

rotation.

7.  Set multifunction switch (1) to 

 (spray). 

Pressure is rising up inside the high pressure hose (visible 

at pressure gauge)

8.  Point the tip of the spray gun into an open collecting con-

tainer and pull the trigger guard at the spray gun.

9.  The pressure is increased by turning the pressure regulat-

ing knob (2) to the right. Set approx. 10 MPa (100 bar) at 

the pressure gauge.

10. Spray the cleaning agent out of the unit for approx. 

1 - 2 min. (~5 litres) into the open collecting container.

1.  Immerse the suction system into a container filled with 

coating material.

2.  Fill coating material into the hopper.

3.  Press inlet valve pusher (4) several times to release pos-

sibly clogged inlet valve

4.  Set multifunction switch (1) to 

 (ON - circulation); the 

unit will start.

5.  Turn the pressure regulating knob (2) to the right until 

the stop is reached.

 

When the noise of the valves changes, the unit is bled and 

takes in coating material.

6.  If coating material exits from the return hose, turn the 

pressure regulating knob (2) back approx. 1 rotation.

7.  Set multifunction switch (1) to 

 (spray). 

 

Pressure is rising up inside the high pressure hose (visible 

at pressure gauge (3)).

8.  Pull of the spray gun and spray into an open collecting 

container in order to remove the remaining cleaning 

agent from the unit. When coating materials exits from 

the tip, close the spray gun.

9.  Adjust the spraying pressure by turning the pressure reg-

ulating knob (2).

10.  The unit is ready to spray.

1.  Switch on the unit.

2.  Turn pressure regulating knob (2) three revolutions to 

the left.

3.  Set multifunction switch (1) to 

 (ON – circulation). The 

hydraulic system is ventilated. Leave the unit on for two to 

three minutes.

4.  Then turn pressure regulating knob (2) to the right until 

stop.

5.  Press inlet valve pusher (4).

 

Sound of the inlet valve is audible.

6.  If not, repeat points 2 and 4