Справочник Пользователя для Sears 486.245332

5

STEP 3: (SEE FIGURE 3)
•  Assemble a hitch arm to the inside of a frame tube 

underneath the tank. Use two 5/16" x 2" hex bolts (A) 
and 5/16" nylock nuts (F). 

Do not tighten yet. Repeat 

for other side.

STEP 4: (SEE FIGURE 4)
•  Fasten the ends of the hitch arms together using two 

5/16" x 1-1/4" hex bolts (B) and 5/16" nylock nuts (F). 

•  Assemble the hitch brackets to the hitch arms using 

two 5/16" x 2" hex bolts (A) and 5/16" nylock nuts 
(F). Position each bolt behind a cross bolt in the hitch 
arms. 

•  Tighten all nuts assembled in steps 3 and 4 at this 

time.

STEP 5: (SEE FIGURE 5)
•  Assemble the boom mount bracket to the rear of the 

frame tubes using two 5/16" x 2" hex bolts (A) and 
5/16" nylock nuts (F).

STEP 2: (SEE FIGURE 2 AND 1)
•  Slide the axle through the two axle brackets.
•  Assemble a spacer (R), a 3/4" washer (H), a wheel 

(valve stem facing out) and another 3/4" washer (H) 
onto the axle. Assemble a cotter pin (M) through the 
end of the axle. Re peat on other end.

• 

Tighten the four nuts which fasten the axle clamps to 

the frame tubes. Refer back to fi gure 1.