Справочник Пользователя для Ridgid R4330

6

Snipe  (depressions  at  ends  of 
workpiece)

Dull cutter blades
Incorrect butted stock
 
Unit not securely mounted

Replace or turn cutter blades.
Butt pieces end-to-end as they are 
fed into planer.
Tighten lag bolts.

Torn grain

Too deep a blade setting
Workpiece being fed against grain
Dull cutter blades

Reduce depth of cut.
Feed other end of board first.
Replace or turn cutter blades.

Fuzzy/rough grain

High wood moisture content
Dull cutter blades
Too deep a blade setting
Incorrect feeding speed

Dry wood before planing.
Replace or turn cutter blades.
Reduce depth of cut.
Check for adequate power supply. 
Check  cord  and  plug  for  damage. 
Check condition of motor brushes.

Uneven depth of cut

Cutterhead  assembly  not  level  with 
planer surface
Unstable roller spring pressure
 
Feed roller worn unevenly

Adjust elevation nuts.
 
Have  service  performed  by  an 
 authorized service center.
Have  service  performed  by  an 
 authorized service center.

Board  thickness  does  not  match 
depth scale indicator

Depth scale incorrectly set
Dirty planing table

Adjust depth scale.
Clean and wax planing table.

Cutterhead height difficult to adjust

Dirty spindle
Worn chain

Clean and lubricate spindle.
Have  service  performed  by  an 
 authorized service center.

Will not start

Not plugged in
Blown circuit
 
Motor failure
 
Loose wire
 
ON/OFF switch malfunction

Motor is overloaded

Check power source.
Replace fuse, reset breaker, or call 
electrician.
Have  service  performed  by  an 
 authorized service center.
Have  service  performed  by  an 
 authorized service center.
Have  service  performed  by  an 
 authorized service center.
Push reset button.

Interrupted operation

Unit overloaded
Circuit overloaded

Reduce load.
Operate  on  circuit  separate  from 
other appliances or motors or con-
nect  to  circuit  with  adequate  amp 
rating.