Справочник Пользователя для Echo PAS-231

IMPORTANT
Lower and upper drive shaft must  be lubricated with high tempera-
ture automotive grease every 25 hours of operation, otherwise
drive shaft assembly overheating and failure can result.

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull flexible cable from the drive shaft housing, wipe clean and

re-coat with a thin coating [15 ml (1/2 oz.)] of  ECHO

 LUBE

TM

.

3. Slide the flexible cable back in the drive housing. DO NOT get

dirt on the flex cable.

4. Install the gear housing and shield assembly.

IMPORTANT
Flat edge of washers (D) must be against drive shaft.

Level 1.

Parts Required: ECHO 0.095" Nylon Trimmer Line 6 m (20 ft.) long.

1. Shut engine off. Lay unit on the ground with head assembly up.

2. Hold drum (A) and firmly turn spool (B) CW (clockwise) until it

disengages from the inner drive. Pull spool from drum. DO NOT
push in on spool when turning.