Справочник Пользователя для Husqvarna 325HS75X-Series

English

 – 9

To ensure good cutting results it is important that the contact 
pressure between the blades is correct. The contact pressure 
is adjusted by turning the screws on the underside of the bar 
clockwise as far as they will go. Then turn the screws 
anticlockwise a 1/4 turn. Lock the screws using the locking nut 
on the top of the bar. Check that the screws are loose enough 
to allow the washers under the screw heads to slide sideways.

When the blades are correctly adjusted the play between the 
blades should be 0,2–0,4 mm, measured at the screws.

The edges of the blades are too hard to be filed. Dull blades 
should be sharpened using a grinder.

Replace the blades if they are bent or damaged.

The gear housing gets hot when the machine has been in 
use. To avoid burning yourself do not touch the gear housing.

Loosen the nuts on top of the bar. Align the bolts in the holes 
on the catcher and fit the bolts. Adjust the blades’ contact 
pressure according to the instructions under the heading 
Blades.