Справочник Пользователя для Husqvarna 323C

 

English

 

 – 7

 

•

Regularly check that the muffler is securely attached to 
the machine.

•

If the muffler on your machine is fitted with a spark 
arrestor mesh then it should be cleaned regularly. A 
blocked mesh causes the engine to overheat, which can 
lead to serious damage. Never use a muffler with a 
defective spark arrestor mesh. 

 

This section describes how to choose and maintain your 
cutting equipment in order to:

•

Obtain maximum cutting performance.

•

Extend the life of cutting equipment.

 

1

Only use cutting attachments with the guards we 
recommend! See the chapter on Technical data.

2

Check the cutting attachment for damage or cracks. A 
damaged cutting attachment should always be replaced.

 

•

When fitting, tighten the nut in the opposite direction to the 
direction of rotation of the cutting attachment. To remove 
it, undo the nut in the same direction as the cutting 
attachment rotates. (CAUTION! The nut has a left-hand 
thread.)

•

Tighten the nut using the socket spanner. 35-50 Nm (3.5-
5 kpm).

 

 The nylon lining inside the locking nut must not be 

so worn that you can turn it by hand. The lining should offer a 
resistance of at least 1.5 Nm. The nut should be replaced 
after it has been put on approx. 10 times.